Mts SWIFT 50 GLP Sensor Uživatelský manuál stáhnout pdf (Strana 63)

Road Simulator

SWIFT 50 GLP Sensors Installation Installing the Transducer

Bolt Torque Sequence

7. Install the vehicle on the road simulator.

Refer to the instructions in your road simulator operation manual.

8. Attach the connector housing (or the slip ring bracket and slip ring) to each

transducer.

9. Attach the appropriate cables from the connector housing or one cable from

the slip ring to the TI or data acquisition.

A. Connect the cable from the Load connector on the connector housing,

or from the slip-ring connector, to the transducer connector on the slip-

ring daughter board of the TI box(es).

B. If used, connect the cable from the Accel connector on the connector

housing to your data acquisition device.

C. Connect the cables from the Shunt A and Shunt B connectors on the

connector housing or the slip-ring bracket to the Shunt A and Shunt B

connectors on the TI box(es)

Connector Side

S50-47

329 Simulator and Hub Mount Side

1 through 10 = M22

(modified lug nuts)

A through H = M10 bolts

1 through 16 = M16 bolts

M5 Threaded

Holes (4)

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69 70

Žádné komentáře

Mts SWIFT 50 GLP Sensor Uživatelský manuál Strana 63