Mts SWIFT 50 GLP Sensor Uživatelský manuál Strana 52

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 70
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 51
SWIFT 50 GLP Sensors Installation
52
Road and Track Vehicles
Installing the Transducer
E. Rotate the tire until the inclinometer reads 0.0°, ±0.1°.
F. Push the Angle Zero button on the front of the TI box. The Angle Zero
indicator will turn on for a few seconds, then turn off indicating that the
Angle Zero procedure is complete.
10. After completing the Bridge and Angle Zero procedures, rotate the wheel
one full revolution clockwise.
This allows the electronics to locate the index pulse for the encoder.
Note The wheel must rotate one-half revolution in the same direction and then
pass over the encoder index point before data collection is started.
11. Perform, “Verifying the Quality of the Zero Procedure,” on page 55.
12. Look at your data acquisition system to verify that the SWIFT sensor is
gathering data.
S50-20
Mounting Screws
Digital Inclinometer
in this position
should read 0°, ±0.1°
Level Bracket
Axes
Icon
Digital Inclinometer
in this position
should read 0°, ±0.1°
Zobrazit stránku 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 69 70

Komentáře k této Příručce

Žádné komentáře