Mts SWIFT 10 MC Sensor Uživatelský manuál stáhnout pdf (Strana 110)

SWIFT 10 MC Sensors

110

Troubleshooting

A two-time-per-revolution

of tire signal is showing up

when the vehicle is driving

straight on a flat surface.

Gain settings: Verify that the TI electronics

calibration file gain settings have not been

modified. Using the T2IXFER program, upload

the current TI settings and compare them to the

original gain setting on the disk provided.

Bridge Failure: If a single bridge is failing due

to overstress, overload induced crack, and so on,

the results could appear as this type of output.

To verify that this is the cause, use the

TI2XFER program to upload the current TI

settings after a zeroing procedure. Load the

transducer for several cycles, without inducing

heat (drive vehicle for a few cycles but do not

use excessive brake heating). Rezero the TI

electronics. Use TI2XFER to upload the new

zero values. Compare them to the previously

recorded zero values. These values should not

change by more than 0.01 to 0.03 for two zeroes

done at the same conditions, on the same

transducer. If the changes are much larger,

remove the transducer from vehicle and contact

MTS.

Troubleshooting Guide (part 9 of 10)

YMPTOM POSSIBLE CAUSES SOLUTION

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 143 144

Žádné komentáře

Mts SWIFT 10 MC Sensor Uživatelský manuál Strana 110