Mts Model FlexTest SE Uživatelský manuál Strana 231

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 264
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 230
J28 Hydraulic Service Manifold Connector
Models FlexTest® IIm/GT/SE Controller Hardware FlexTest SE Controller Connections
231
Cable specification The J25 HPU and J51 Box In connectors are 15 pin type D male connectors.
15 contact type D female EMI connector.
Cable—24 AWG, 10 conductor with braided shield with drain wire
connected to metallized plastic backshell to the chassis.
Jumper plug required If connector J25 HPU is not used, you must install a jumper plug to maintain the
integrity of the interlocks. Use jumper plug PN 039-713-301 or jumper pins: 1–7,
2–3–5, 6–9, 8–10–11–12, 6-9.
For an electrical diagram of J25, see page 132.
J28 Hydraulic Service Manifold Connector
See “J28 Hydraulic Service Manifold Connector” on page 134.
Zobrazit stránku 230
1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 263 264

Komentáře k této Příručce

Žádné komentáře