Mts SWIFT 30 Sensor Uživatelský manuál stáhnout pdf (Strana 51)

TISHUNT - Transducer Interface Shunt

SWIFT 30 Sensors Software Utilities

Option 0 Use this option to exit the program.

Option 1 Use this option to read the shunt tolerance, the last measured shunt values, the

reference values, and the shunt error status.

Note The shunt error status is not maintained over power cycles, so it is only

valid if the shunt is executed after power is applied. Refer to, “Shunt

Error Status,” on page 57.

This option asks if you want to save the data in a file. Answer Y or N, and if Y,

then supply the file name when prompted. The following is typical of what is

displayed when this selection is made:

Note If you save to a file, the file is created in the same directory as the tishunt

program. The file name must contain less than 80 characters.

Option 2 Use this to set the shunt tolerance. When selected, the following is displayed:

Reading Shunt parameters from TI... OK

Shunt Delta Tol: 10.000%

FX1 Ref: 3.935 Measured: 3.934 Error Status: 0

FX2 Ref: 3.932 Measured: 3.932 Error Status: 0

FY1 Ref: 3.937 Measured: 3.930 Error Status: 0

FY2 Ref: 3.929 Measured: 3.930 Error Status: 0

FY3 Ref: 3.932 Measured: 3.932 Error Status: 0

FY4 Ref: 3.931 Measured: 3.932 Error Status: 0

FZ1 Ref: 3.930 Measured: 3.935 Error Status: 0

FZ2 Ref: 3.932 Measured: 3.934 Error Status: 0

Save to a file (y/n)?

The Shunt Tolerance specifies how much the measured shunt deltas may

deviate from the Ref settings, and still be considered good.

The value is entered as a percentage, where "1.0" would mean 1.0% of the

Ref settings.

For example: if the tolerance is 1%, and the Ref setting is 8.0, then the

measured delta must be between 7.92 and 8.08 to be considered good.

It is not necessary to reboot the TI when this value is changed, but a

Shunt Calibration must be executed to update the Shunt Error Status

words.

Also note that a parameter download will overwrite this value.

Enter tolerance (in percent):

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 171 172

Žádné komentáře

Mts SWIFT 30 Sensor Uživatelský manuál Strana 51