Mts 709 Alignment System Uživatelský manuál stáhnout pdf (Strana 89)

Get Specimen Offset Values

709 Alignment System Specimen Offsets

3. Establish the bent front offset reading.

Because load train components cannot be perfectly machined, some initial

offsets are inherent. Establishing bent front values allows the 709 Alignment

System to take this into account during the alignment adjustments.

A. Select the Bent Front tab.

B. Install and clamp the specimen in the standard orientation; that is

install the specimen such that gauges G4, G8, and G12 are facing

toward the front on the load unit with G4 being the top gauge.

C. Click the Read button to take a reading.

D. Click the Add button to save the values.

E. Unclamp and clamp the lower grip.

F. Repeat steps C, D, and E until you have saved three sets of bent front

values.

G. Unclamp and clamp the upper grip.

H. Click the Read button to take a reading.

I. Click the Add button to save the values.

J. Repeat steps G, H, and I until you have saved three sets of bent front

values.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 157 158

Žádné komentáře

Mts 709 Alignment System Uživatelský manuál Strana 89